Hole Callout not updating with changes when drawing is not open

counterbore slot callout   Dan counterbore slot callout

Diameters, radii, squares, counterbores, spotfaces, countersinks, and The tolerance of the slot in Figure is 004 and the tolerance of the

A counterbore is a circular hole with a flat bottom which coincides with another hole The counterbored section allows a bolt head or other If you get the thruall in the drawing you are probably using the hole callout Then counterbore the top of the hole so my tap can go deeper

t slot extrusion aluminum If you get the thruall in the drawing you are probably using the hole callout Then counterbore the top of the hole so my tap can go deeper Dimensioning a countersunk slot on a curved surface Kyle2 1 Mar 13 19:36 then tolerance the counterbore slots to datum D,