How to dimension a slot in a drawing?

When you are dimensioning a drawing with a slot, do you need to show the center lines of the slot and not the radii? Under the Annotate Tab

How to dimension a slot in a drawing? Figure 1: Part drawing with basic dimensions locating 2 bore holes from the Datum Reference Frame slot) Figure 2: Datum Features A, B

When you are dimensioning a drawing with a slot, do you need to show the center lines of the slot and not the radii? Under the Annotate Tab

slot all V-Slot Dimension Drawing is available on the reference page Always handy when inventing :) Share 0 Tweet 0 +1 ← Older Post Newer Post →

slots), give To avoid confusion and the possibility of error, no dimension should be repeated twice on any sketch or drawing

slot gradis The dimensions I want on my drawing are pretty much just what I have in the sketch 2: Is there any way in a sketch to contain a point to be at

Pre-selecting sketch curves and then applying slot creates slots of equal size across all curves, lines, or arcs, linked together with one single dimension You